CINTER-SL SCREED ’J’ is based on carefully selected solventless epoxy resin composition. It is a two component system consisting of Base (component A), Hardener (component B). It is a self-leveling composition and forms a very smooth, attractive, hygienic, hard wearing and chemical resistant floor joint filling and repairing.

Product Features

• Hygienic: It provides jointless flooring and is also used as a sealing of floor expansion joint, making it dust free and is easy to clean because of smooth surface.
• Chemical Resistance: It is resistant to most chemicals
• Wear Resistance: It provides a tough floor topping to withstand foot, light and heavy vehicular traffic
• Life span: It increases the life span of joints and floor.
• Economical: It reduces the cost of material by adding the aggregates.
• Recommended Uses

CINTER-SL SCREED ‘ J’ is recommended for use where extremely hygienic, abrasion, chemical resistant and dust free environment is required. It is ideally suited for following industries:

• All mechanical industries, textiles industries, paper industries, automobile workshop and any type of floor repair.
• Pharmaceutical Industries
• Electronic Assembly Area
• Clean Rooms
• Paint Industries
• Dyeing Units
• Food Processing Industries and any other Industries
  
  

Product Specifications

Surface Preparation
Successful repair to concrete floor & joint depend totally on correct surface preparation. Particular care should be taken to ensure all surfaces are completely free of laitance, oil, dust, grease, plaster, paint, and corrosion etc.etc. Oil and grease deposit should be removed by steam cleaning or detergent scrubbing. Smooth surfaces should be mechanically roughened by scabbing or needle gun to form a good key. Edges of the areas for the repair must be saw cut to 5-10 mm to avoid leather edging. Finally the complete area should be blown clean with oil free compressed air.

Method of Application
Mix the contents in container of CINTER-SL SCREED ‘J’ base thoroughly well to redisperse settled matter if any. Pour the base into a clean vessel. Add the required quantity of hardener to the Base and mix thoroughly preferably by a mixture. Spread the mixture to the floor immediately to the required thickness by means of rollers and serrated trowels. The floor should be rolled by a spiked roller to remove trapped air. The floor shall self-level to uniform colour and smoothness.

Handling & Safety
Take normal precautions to avoid skin contact. Provide well-ventilated conditions or use suitable respiratory protection. If any areas where product comes into contact with skin, wash with soap and water. Splashes in the eyes should be well flushed out at least 10 minutes with fresh water and medical attention sought.

NOTE:This information given in this folder is of a very basic nature and without warranty. The users are advised to contact us before using for a specific application